
               --------------------------------------------
                 TP-LSMULTI-SDK Firmware Update Procedure
               --------------------------------------------

The following steps describe the procedure for updating TP-LSMULTI-SDK-supported
scanners with a new firmware file.

		  Device		 Firmware file
		------------		---------------------
		TP-3800HA		Jaguar.v.vv.idx
		TP-3000A-ED		TP-5000.DSP.v.vv.idx
		TP-3100A-ED		TP-5000.DSP.v.vv.idx
		TP-3800HA-ED		TP-5000.DSP.v.vv.idx
		TP-4x4A			TP-4000.DSP.v.vv.idx
                TP-4100A-ED             TP-4000.DSP.v.vv.idx
                TP-4100UA-ED            TP-4100U.v.vv.idx
                Agile TP                TP-4101.v.vv.idx
                TP-4101B                TP-4101.v.vv.idx
                TP-4800PA-ED            TP-4800.v.vv.idx
		TP-5000A-HD		TP-5000.DSP.v.vv.idx
		TP-5100A-HD		TP-5000.DSP.v.vv.idx
		TP-5300A-ED		TP-5300ED.v.vv.idx
		TP-5300A-HD		TP-5300.v.vv.idx
		TP-5500HA-HD		TP-5000.DSP.v.vv.idx

		Note: v's = version number digits

The pathing will depend on the installation. The instructions will use the term,
[INSTALLDIR], to refer to the root path selected when originally installing the
software. 

Step 1.  If running an L-1 Identity Solutions TouchPrint application, the system must 
         be booted with the scanner attached and perform a maintenance exit.

Step 2.  Invoke [INSTALLDIR]\Tester\Firmware\FirmwareUpdate.exe.

Step 3.  Select the appropriate firmware filename (see list above), and press 
         "StartUpdate".  Do not disconnect or otherwise interrupt the update process,
         as this could render the device inoperable.  

Step 4.  Verify that the "Current Version" has been updated with 
         the version number which matches the firmware file.

Step 5.  Exit the application


   -------------------------------------------------------------------------
   Special Instructions When Updating AgileTP from Firmware Versions Earlier 
   than v1.10:
      Updating the firmware from any version earlier than v1.10 to any newer 
      version on an AgileTP device is a two step process. First the firmware 
      will need to be updated to v1.10, and then it may be updated to the 
      most current firmware version.  Any attempt to go directly to the most 
      current firmware version will result in an update failure and possibly
      render the device inoperable.
   -------------------------------------------------------------------------
